3D Embroidery Fabric with Raised Flowers Flat Stitch Leaves and Water Soluble Lace Edges for Womenswear

The embroidery combines two stitch constructions in one repeat. The leaves are worked in flat stitch, sitting close and even against the base; the flowers are built up in 3D so they lift away from the surface. Because the two sit at different heights, the motif reads as layered rather than as a flat outline — the raised flowers cast their own shadow, which is where the dimensional effect comes from.

The flowers are scattered across the width rather than locked into dense bands, with open space between the clusters. That spacing gives two ways to cut the fabric: keep a panel whole where the repeat should stay visible, or isolate single flower clusters for placement work.

Along both selvedges runs a border of six-petal flowers worked in water-soluble embroidery — the embroidery holds its shape on its own, so the border reads as a scalloped lace edge along the full length of the selvedge.

The base is an N/P fabric finished with 100%P embroidery thread, and the hand feel is soft and comfortable. Width is 51/52 inch at 180g/m.